LabVIEW Workshop @ CERN 2019

Find out more and APPLY

About Workshop

The workshop is dedicated for beginners who have no previous experience with LabVIEW or used it a few times.
During the course, which is based on official National Instruments (NI) training materials, we'll learn together how to program in LabVIEW and how to interface with NI hardware. The workshop prepares you also for CLAD exam, certifying Your LabVIEW software proficiency.
Presentations and materials are in English.

The course will be guided mainly by Patryk Jankowski (EN-SMM-MTA) with an assistance of the CERN LabVIEW support team (EN-SMM-MTA).

Pre-requirements: No experience required, but a bit of programming awareness is recommended.
Advisable: Bring your own laptop to follow demonstrated examples!


Time & Location

The course will be held after work from 6pm to 8pm.
It will start on Thursday 19th of September and then continue on consecutive Mondays for 6/7 weeks.
Before filling the application form, make sure you are able to attend to the course within specified dates.

Where: IdeaSquare (bldg. 3179), CERN Meyrin (map below)

IdeaSquare is a dedicated test facility at CERN that hosts detector R&D projects It also can host special innovation-related events. To check more information about this great environment, go here: http://ideasquare.web.cern.ch/.


Apply

Sign-up Form

Application is open until 18:00 15.09.2019!


Contact

If you have some questions, send us an email!

Disclaimer: We work at CERN, and this is our after-work self-development activity. We are LabVIEW fans who want to share the knowledge about it.